Trainee Instrumentation And Control Engineering Job in GMR Airport India

Position Instrumentation Engineering

Educational Qualification:

B.tech in Instrumentation Engineering from recognized Technical Board/ Institute with not less than 50% marks.

Diploma (Preferred)

Job description

Exposure in various field equipment like all types of flow meters, valves, level transmitters, load cell systems, networking and communication, panel wiring, troubleshooting with the help of drawings & instrument manuals, etc.

Good exposure in Maintenance and Repair of instruments based on PLC & SCADA system, SQL, and network communication.

Sound Knowledge of various sensors used for temperature, pressure, position control, read switches, photosensor, etc.

Experience in load cell, pressure transmitter - Calibration, replacement, and troubleshooting, etc.

Sound Knowledge of I/O Control Wiring and Circuit and drawing reading.

Should have exposure in project Erection, Commissioning, DQ, IQ, OQ, PQ, etc related Instrumentation activities.

Should have experience in ASRS PLC programming, VFD configuration, validation of systems, servo drive, AC-DC drives of different make, PM, BM activities in machines, SOV, TT, PT, LS, troubleshooting of all instrument as mentioned etc .

Electrical Utility maintenance is preferable for candidates.

Sound knowledge of Budget preparation, inventory management, manpower management, SOP documentation, Audit, and Liaison with Govt.

Ensure proper documentation and record-keeping in line with GMP & FSSAI requirements.

Work under general supervision, performing routine and regular tasks as per manufacturing processes and associated documents.

Perform manual/electronic data entry requirements at each operation.

Undergo training in required processes.

Demonstrate tasks when certified to uncertified operators and check their work.

Compliance with Companys Health & Safety policy and procedures.

Key Responsibilities:

Erection, Installation, and commissioning Of Instrument Systems.

Checking of Instrument Installation as Per P & I Drawing

Calibration of instruments, Like PT, FT, TT, DPT, Control Valves, etc. Commissioning and Erection Experience in Pharma plants, utility plants, boiler systems.

Hands-on Experience Loop Checking and Functional Testing of All Instruments

Line Up and Error Correction the Actuators, Control Valves, and Field Instruments

Commissioning assistance of SWAS Panel, SCADA system

Servicing and Calibration of Pneumatic and Electronics Positioned and Control Valves

Experience in Instruments Handles Like Temp Transmitter, Temp Sensors (RTD, Thermocouple, Ni-1000), Pressure Transmitter, Pressure Gauge, Pressure Sensor, Diff. Pressure Transmitter, VFD, Temp. Controller, Level Switch, Level Transmitter, Flow Meter, control valve, i/p Etc.

Analyzing Data and Producing Reports Based on Them. Experience in the areas of

SCADA and HMI Pages, PLC, HMI, DRIVE.

Installation, Testing, and Calibration of Different Types of Transmitter and Instrument used for measurement of flow, level, pressure, and temperature.

Checking of P&ID, IO List, Cable schedule list, panel wiring, junction box, and loop diagram in Auto CAD Software.

Instrument Loop Testing, Cable laying, and Termination as well as commissioning of the system.

Fault finding and troubleshooting of instrument and pneumatic system.

Configuration of different Communication Protocols like Control Net, Device Net Ethernet, Modbus, Profibus, CAN, and OPC.

Knowledge of instrument index and hookup diagram.

Knowledge of ABB makes Pro control P13 DCS System and Yokogawa CS-3000DCS.

Knowledge of Industry standard IEC, CE Mark, NEME, and Hazardous Area Classification.

Experience in Fiber optic cable and its connection.

Experience:

Work: 1 year (Preferred)

Total work: 1 year (Preferred)

Industry:

Construction, Electricity, Gas, Oil & Waste Services